Was your PS3 reading all disc types? Any problems accepting discs or ejecting discs?. Did you have any problems with over heating and shutdowns. Inventory your PS3 condition before the update in your mind. The PS3 is not hard to tear apart, but you must map things out to know where everything goes back. Consider if you are any good at this sort of stuff or not. If you are out of warranty, then you must decide to on if you are going to open your PS3 up or not. (for this reason, if somebody wants to sell you a PS3 that is locked in the loop, make absolutely sure that hard drive is included. If it's in 40% range of completion, it can be anything from a bad or loose hdmi connection to fan malfunction, possibly the hard drive (try re-seating harddrive), Power supply (voltage variance or loose connections), WiFi board, USB connector problems, etc! But until you fix it, it will continue to loop in update mode. It can be the disc insertion sensor, the main ribbon cable or simply a loose connection. Generally if it stalls in the 60-70 range, this indicates a problem with the BluRay (even a dirty lens or bad diode) player in some way. Depending on where in this process it stalls (in the loop % of completion), can indicate where the possible failure is. If it finds one, then you'll get that 8002F14E code (or similar) and it won't complete until you fix the hardware problem it found. Your PS3 is checking your entire system hardware for faults. The Nand (one adjacent to Super Companion/south bridge) has NOT been flashed until this phase is complete. What's happening is that the PS3 is running in Nand flash mode. But the actual flashing of PS3's Nand doesn't complete until it reaches 100% and reboots. In case it's related to this update process. This is why Sony wants you to send in your hard drive with your PS3 for repairs. If you do, it could keep it from ever finishing that update. Whatever you do don't format the hard drive you used in the Update Flashing of your PS3 if it's looping. Recheck all connections and cables and/or re-seating your hard drive. It could be simply locked in an update loop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |